Installation & Specs
There are so many uses for concrete pavers. Choose an installation that best meets your requirements for use and desired look of the finished project. Your Wausau Tile representative can assist you in determining which installation best suits your needs, or answer any other questions you may have. Each installation listed shows a pedestrian or vehicular method.
| Property | Value | Test Method |
|---|---|---|
| Compressive Strength | =>8,000 psi ave | ASTM C140 |
| Flexural Strength | =>800 psi ave | ASTM C293 |
| Water Absorption | <6% | ASTM C140 |
| Freeze/Thaw | =<1% loss of dry weight (50 cycles) | ASTM C67 |
| Center Load | 1,850 lbs | WTCL 99 |
Installation Methods
Sand and Bituminous Installation
The most economical method for installing architectural pavers is sand setting. It also allows for easy replacement, repair and adjustment. Sand-set installation can be used where soils are well drained and settling is not expected. Proper compaction of the setting bed and the gravel subbed is mandatory. For stability, the sand bed should be no thicker than one inch. Joints should be 1/16" to 1/8", and filled with swept sand. Perimeter restraint is recommended. Bituminous installation is indicated where greater stability is required.
Sand
Bituminous
Mortar Thin Set and Thick Set Installation
For grouted paver installations, one of two mortar set methods may be used. Stability of the subbase and concrete substructure is critical. Setting bed, grout and mortar must include a latex or acrylic admixture or waterproofing (follow the recommendations of the admixture manufacturer). Expansion joints must allow for movement. Perimeter restraint is recommended.
Mortar Thin Set
Mortar Thick Set
Pedestal Installation Details
Tab and pedestal installation is recommended for pavers set atop building structure. Coordination of your installation with a qualified installer, landscape architect or architect is recommended. Perimeter restraint must be carefully considered.
Wausau Pedestal With Tab at Wall
Wausau Tab at Wall
Wausau Pedestal at Joint
Wausau Tab at Joint
Installation
The Wausau pedestal system provides height adjustment from 3/8" to 21". Slopes up to 5/8" per foot are allowed. Maximum load per pedestal is 3,000 pounds. The waffle-reducer is a base with four rings for height adjustment between 1/2" and 2 1/8".
Wausau Terra-Stand Pedestal
 |
 |
|||||
| Full Assembly | Accomodates slope | |||||
|
||||||
 |
||||||
| Waffle Reducers | ||||||
